水电站布设拦污排技巧
浮设在进水口前一定水域的前沿，用以拦截水流中漂浮的排架式拦污设备。在漂浮杂物较多的河道上，如仅设拦污栅，会使栅前的污物大量堆积，清理不及时，将堵塞栅孔，影响 水。在拦污栅前设拦污排，两者结合使用，效果！
柏泰聚乙烯拦污排浮筒设备连接使用安全 ，因拦渣装置浮筒材料外壳采用食品lldpe为原料内部聚苯乙烯填充发泡，浮筒韧性强，外壳强度高，即使是汛期受到强烈的树木杂物撞击也不会破裂！单个浮筒浮力大，有整体式和两片组合式，施工安装简单，使用 可达15年以上！
水电站布设拦污排技巧浮式拦污排的纵向轴线与拦污排 水流主流方向的夹角不宜过大。水流主流方向应按正常发电和泄洪两种工况来分别考虑。拦污排纵轴线与主流方向的夹角越小，污物对拦污排的冲击力就越小，污物绕过拦污排的可能性就越小，拦污效果也就越好；此外，夹角越小，沿拦污排轴线的分向力就越大，导漂效果就越好。 据工程经验，建议该夹角的角度小于30°。
floating is located at the front of a certain water area before the intake to intercept the floating type of fouling equipment in the water. in rivers with more floating debris, if only a barrier is set up, a large amount of debris will accumulate in front of the barrier, and if the cleaning is not timely, the barrier hole will be blocked and the water diversion will be affected. in the front of the trash rack, a sewage platoon will be set up. the combination will be effective.
botai polyethylene contamination removal buoy equipment connection is safe and reliable, because the slag removal device buoy material shell using food-grade lldpe as raw material filled with polystyrene foam, buoy toughness, high shell strength, even in flood season by strong tree debris impact will not break! the single buoy has a large buoyancy, has the integral type and two piece combination type, the construction and installation are simple, and the service life can be more than 15 years.
the angle between the longitudinal axis of the floating sewage interception row and the main flow direction of the sewage interception row should not be too large. the main direction of water flow should be considered separately according to the two conditions of normal power generation and flood discharge. the smaller the angle between the vertical axis and the main direction of the interception row, the smaller the impact force of the pollutant on the interception row, the less the possibility of the pollutant bypassing the interception row, and the better the interception effect; moreover, the smaller the angle, the greater the dividing force along the axis of the interception row, and the better the drift conduction effect. according to the engineering experience, it is suggested that the angle of the included angle is less than 30 degrees.